News
News Center
Correct method of adjusting the washboard
Release time:
2024-05-20
The correct method of adjusting the washboard mainly includes adjusting the height, pressure and angle of the washboard, as well as the gap between the two washboards. These adjustment steps are essential to ensure the normal operation of the thread rolling machine and the quality of the thread rolling.
Adjustment of the height of the washboard: First, lay the washboard flat, and then gradually raise it until the best effect of the washboard is achieved. If the thread rolling board is too low, it will lead to slower thread rolling speed and poor quality; if it is too high, it will lead to insufficient thread rolling strength and affect the effect of thread rolling.
Adjustment of the pressure of the washboard: The pressure of the washboard will also affect the quality and efficiency of the washboard. Excessive pressure may lead to increased wear of the washboard and the wire knife, affecting the service life of the wire rolling machine; while too little pressure will lead to poor wire rolling effect. The correct adjustment method is: adjust the thread rolling machine to the normal thread rolling speed, and then gradually increase the pressure of the thread rolling board until the ideal thread rolling effect is achieved.
Adjustment of the angle of the washboard: In general, the angle of the washboard should be opposite to the direction of the washboard to better cut gluten and meat. If the wear degree of the cutter head of the thread rolling machine is relatively large, it is necessary to increase the angle appropriately.
Gap adjustment between the two washboard: just install the washboard in the moving mold groove and the fixed mold groove, and do not need any thin pad or iron sheet under the mold. Appropriately adjust the gap between the two washboard, and then fasten and fix it. If the gap is too large, the blank will not enter the gap between the two plates; if the gap is too small, the blank will not be correctly rubbed.
Adjustment of fastening bolts: if the fastening bolts are tightened a little, the clearance of the flat plate die at the end becomes smaller, and the clearance should be adjusted to the depth of the rolling thread until it meets the requirements.
Through the adjustment of the above steps, it can be ensured that the thread rolling machine can still maintain stable performance and high-quality thread rolling effect after working for a long time.
Next Page
Latest News
2025-06-07
Get a Free Consultancy
Tengma Standard Parts and Tools Co., Ltd.
Tengma tools specializing in the production of various specifications of the washboard, rolling wheel, and according to customer demand for a variety of standard customization.
202 Zhencheng Road, Jiangyin City, Jiangsu Province
Quick links
Copyright©2024 All Rights Reserved of Tengma Standard Parts and Tools Co., Ltd